Removal of Roll Pins on Shift Selector

Click Here To Visit Phoenix Hummer Repair

Click here for a listing of all HUMMER Network sponsors

The Hummer Knowledge Base

Removal of Roll Pins on Shift Selector:

To remove them you need a parallel punch and a hammer plus a block of wood with a small hole drilled in it, to support the lever while you hammer away.

You can remove them in either direction, but toward the doghouse will be easiest. Place the block of wood against the knob and position it to allow the roll pin to enter the hole. Use a punch that's slightly smaller than the roll pin, and gently tap the pin through the knob. Three hands will make the job easier!

Back to main page

The Hummer Knowledge Base is a collection of informative posts from the Hummer Network forums and mailing lists, contributed material and links to outside web sites.
The Hummer Network is not responsible for the accuracy of the information contained herein or on outside web sites, nor for any situation arising from the use thereof.
© 2006-2011 by The Hummer Network. No material from the Hummer Knowledge Base may be reprinted or republished in any form without permission.