|
General/Measuring Ground Clearance:
Subject: HML: Re: Sagging Springs
Date sent: Sat, 28 Jun 1997 19:57:10 -0500
AMG's position is if the clearance is less than 16", warranty
will replace the coils asuming the truck is still in warranty, of course.
Ross
Overseas Motors, HUMMER in Dallas
Measuring from where to where?
Bottom of crossmember or driveline protection (lowest part under
the vehicle)
Mike
Date sent: Mon, 30 Jun 1997 17:58:58 -0500
Subject: HML: sagging springs
mike domanski wrote:
Measuring from where to where?
Bottom of crossmember or driveline protection (lowest part
under the vehicle)
Mike
- Set tire presure, front 26 PSI, rear 28 PSI
- Position vehicle on hard flat level surface
- remove all load
- If you have added a winch or aftermarket brushguards, may
invalidate warranty replacement of coil springs. 5. Bounce front
and rear of vehicle up/down several times to make sure it is
fully settled. 6. measure the distance from edge of each lower
control arm front crossmember bracket to shop floor 7. If
distance is less than 16" and/or if the left and right side
measurements differ by more than 3/4", then warranty will
replace springs, IF vehicle is covered by original warranty and
has not been modified.
Good Luck
Ross
Overseas Motors, HUMMER in DALLAS
|
